Immediate in store
Withdraw as of now your products in this store
With a torque range from 10 up to 60 Nm, Giustaforza II 10-60 Pro is standard equipment of the best cycling workshops. Design is inspired by smaller Giustaforzas, constructive quality and reliability are state-of-the art.
Capacity from 10 up to 60 Nm:
the torque range of Giustaforza II 10-60 Pro is ideal for the elements of the bicycle with the highest torque specifications (bottom bracket, cassettes). In use, always refer to the torque values specified on technical documents or printed on the parts themselves.
Easy to use:
unlock the wrench-end knob by gently pulling it, and set the desired torque value rotating the knob and reading the torque on the scale. After setting the torque value, push the knob back in place, to prevent unwanted changes to the set value while using the wrench
depending on the rotation sense of the part you want to tighten, push the square section bar through the wrench head to one side or the other
using the tool, a loud ‘CLICK’ and a 3° free-movement tells when the torque has been reached
always take the wrench to minimum torque value after use.
the +-4% tolerance is guaranteed for 5000 cycles (5000 ‘clicks’), then the wrench should be re-calibrated. Calibration is a service we offer in our laboratory in Lugano (CH) at the cost of 50 CHF plus shipping expenses (may vary depending on the countries: check terms & conditions with the national distributor). With every calibration, the tolerance of +-4% over nominal value will extend for 5000 cycles. After calibration, the wrench will return to the customer with a calibration certificate.