Immediate in store
Withdraw as of now your products in this store
Targeted at professional users, Giustaforza II 2-16 Pro is red anodized and has a reversible ratcheting head. The light aluminum body keeps the weight down to a record-breaking sub-200g value, less than half the weight of other torque wrenches in this range of torque. This is paramount to get the right feedback at low torque values, without mistaking the effort to hold the tool with the applied torque.
Easy to use:
set the desired torque rotating the wrench end knob, reading the torque value on the scale (scale resolution is 0,5 Nm, integers on one side, 0,5 on the other);
insert the appropriate bit (depending on the bolt you need to tighten);
using the tool, a loud ‘CLICK’ and a 3° free-movement tells when the torque has been reached;
always take the wrench to minimum torque value after use.
the +-4% tolerance is guaranteed for 5000 cycles (5000 ‘clicks’), then the wrench should be re-calibrated. Calibration is a service we offer in our laboratory in Lugano (CH) at the cost of 50 CHF plus shipping expenses (may vary depending on the countries: check terms & conditions with the national distributor). With every calibration, the tolerance of +-4% over nominal value will extend for 5000 cycles. After calibration, the wrench will return to the customer with a calibration certificate.
The wrench is available by itself or as DELUXE version, equipped with a bicycle-specific bit set.
Bits include a 100 mm-long extension, three 100 mm-long bits (hex 4, hex 5 e T25) plus several other Torx and hex bits in standard lenght (25 mm). That covers all the needs of newest Shimano, Sram and Campagnolo high-end groupsets, plus those of reversed-bolt stems.
All bits are manufactured from S2 special steel, with very high (62 Hrc) surface hardness, to ensure maximum durability.
Detail of bits: